Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

FEG Pa-63 magazine release disassembly

Discussion in 'Handguns: Autoloaders' started by SkunkApe, Dec 27, 2002.

Thread Status:
Not open for further replies.
  1. SkunkApe

    SkunkApe Member

    Joined:
    Dec 25, 2002
    Messages:
    744
    Location:
    Bar Nunn, WY
    My FEG PA-63 is dropping magazines when I shoot it, apparently due to recoil and a very short length of engagement of the mag release. I'd like to remove the magazine release assembly to have a look, but I can't figure how to get it out. Any help?
     
  2. SkunkApe

    SkunkApe Member

    Joined:
    Dec 25, 2002
    Messages:
    744
    Location:
    Bar Nunn, WY
  3. denfoote

    denfoote Member

    Joined:
    Dec 25, 2002
    Messages:
    4,622
    Location:
    Near the border of occupied Azlan and Mexico.
    You might have to take it to a gunsmith. I did a search on Google, Yahoo and Profusion and found nothing on the care and feeding of the PA-63. www.makarov.com has a little information on it, but that is not Dr. Bloss's cup of tea.
    Sorry!!!:(
     
  4. SkunkApe

    SkunkApe Member

    Joined:
    Dec 25, 2002
    Messages:
    744
    Location:
    Bar Nunn, WY
  5. SkunkApe

    SkunkApe Member

    Joined:
    Dec 25, 2002
    Messages:
    744
    Location:
    Bar Nunn, WY
    Nevermind. I figured out. You have to take off the trigger gaurd. I stretched the mag release spring a bit. Range test tomorrow.

    P.S. Anyone wanna a buy an FEG PA-63 cheap?
     
  6. mephisto

    mephisto Member

    Joined:
    Jan 3, 2003
    Messages:
    324
    Location:
    In a geographic anomaly
    $ 50.00

    Mephisto
     
  7. Ledbetter

    Ledbetter Member

    Joined:
    Dec 24, 2002
    Messages:
    621
    Location:
    Carpinteria, California
    Buy it fast before he fixes it again.

    :evil:
     
Thread Status:
Not open for further replies.

Share This Page