1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Finally fixed my Marlin 795

Discussion in 'Gunsmithing and Repairs' started by Muzzlelover, Dec 11, 2012.

Thread Status:
Not open for further replies.
  1. Muzzlelover

    Muzzlelover Member

    Oct 29, 2012
    When I went to clean my 795 a couple days I noticed the front stock scew had got up under the floorplate(which you need to remove to get the stock off)and every time I tried to unscrew it it would pull the floorplate up :banghead:to the point I thought the floor plate was going to snap so once I HAMMERED it down past the screw I took a small thin washer and voula it worked!not only does it keep the screw from getting undeneath the floorplate but it increased accuracy.Hope this helps other 795 owners.If any member on here knows any other improvements for the 795 please share.
Thread Status:
Not open for further replies.

Share This Page