Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

fnicky Kimber Eclipse Pro II

Discussion in 'Handguns: Autoloaders' started by yz450, Mar 7, 2009.

Thread Status:
Not open for further replies.
  1. yz450

    yz450 Member

    Joined:
    Mar 1, 2009
    Messages:
    3
    I bought a Kimber Eclipse Pro II about a month ago and it is the most difficult pistol to reassemble. Today, I had the spring stick in the assembly after I removed the take down tool. Has anyone had similiar challenges? Also, does any one know a better technique when it comes to putting the slide stop pin back in its place? That little pin that needs to be pushed in to unblock the slide stop is a bear to work with. I am thankful for any comments or suggestions.
     
  2. JDGray

    JDGray Member

    Joined:
    Sep 16, 2005
    Messages:
    5,130
    Location:
    SW MI.
    I used to use a popsickel stick to push the plunger in, while inserting the stop, but later I reshapped the edge with more taper, so it slides in easier. Hard to explain, but not hard to do.:)
     
Thread Status:
Not open for further replies.

Share This Page