I have been doing lots of range brass. When I first started I would deprime the cases and then tumble them.
I was useing my new single-stage Hornady Lock n Load press with the Lee universal depriming die.i did tens of thousands of cases and all the grit & grim ruined the press. It wore away at the aluminum frame. The ram got slop in it from the front of the press to the back of the press.
So after that happened I quit depriming range brass that I sell.if the range brass is dirty I wet tumble it with no pins, just the usual mix of 1/2 a teaspoon of Lemi-Shine, a cap full of ArmorAll Wash & Wax and a small squirt of Dawn dish soap in hot tap water.
Drain the black water off, rinse, then fill the drum up with fresh warm tap water and tumble the brass for another five to ten minutes to get the brass nice & clean.
My depriming dirty brass is all done, if it is not clean it does not go on any of my presses.
I liked the Frankford wet tumbler so much I bought another one.
One is to use with out the pins and the other is to use with the pins.
Cardinal you can stop by any time. I live right in Arlington about four miles off of I-5 exit 208.
When you stop by PM me and I will send you my address.
When I get this reloading shed done I will have two single stage Lock n Load presses, a Hornady AP press, a Dillion 650, a Redding T-7 press, a Rcbe Rock Chucker press, a cheap lee sinole stage press my son gave me and maybe a Lee Progressive press set up. You are welcome to try any of them out.
I bought the Hornady AP setup and the Dillion 650 so I can compare them side by side.
The Hornady guys say Hornady in the best.
The Dillion guys say Dillion is the best.
I will see which one is the best for me.
The plus side of having these set up side by side will be for guys can come over and load on each of them and see what they like better before they invest in a press they never used.
It is going to be nice having about sixteen feet of loading bench, more if I need it.