Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Fuff and Buff

Discussion in 'Handguns: Autoloaders' started by kowenjr, Aug 27, 2007.

Thread Status:
Not open for further replies.
  1. kowenjr

    kowenjr Member

    Joined:
    Apr 14, 2007
    Messages:
    60
    Location:
    Nicholasville, KY
    This may be a stupid question but I'll ask anyway. Could a fluff and buff job void a warranty? I've been doing a lot of research on the Kel-Tec P3AT and read that this was beneficial for proper functioning for them yet I would not want to do anything that would effect the warranty. Any thoughts?
     
  2. MikePGS

    MikePGS Member

    Joined:
    Aug 4, 2006
    Messages:
    2,348
    Location:
    Metro Detroit, Michigan
    Thats a great question...but believe it or not, i think you might have an easier time finding the right answer at ktog.org, the kel-tec group. Welcome to the high road... since i'm welcoming you here, i hate to scare you away to another site, so please stick around:)
     
  3. Brian Williams

    Brian Williams Moderator Emeritus

    Joined:
    Dec 22, 2002
    Messages:
    9,864
    Location:
    Kampong Cham, Cambodia
    Welcome to THR, stay around awhile, but KTOG is the best resource for Kel-Tecs.
     
  4. kowenjr

    kowenjr Member

    Joined:
    Apr 14, 2007
    Messages:
    60
    Location:
    Nicholasville, KY
    Thanks for the welcome! I'll be back...
     
  5. MICHAEL T

    MICHAEL T Member

    Joined:
    Feb 3, 2004
    Messages:
    6,011
    Location:
    outback Kentucky
    The F&B was mainly for 1st Gen guns New ones are not likely to need I have 3 of 2nd gen guns and all came out of box , I oiled rails and went to shooting , 50 rounds later they got first real cleaning.
    Today all past 500 mark and still running fine
     
  6. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,379
    Location:
    SE Pennsylvania
    The simple answer is "NO", but all the answers above are good.
     
Thread Status:
Not open for further replies.

Share This Page