Outlaw75
Member
Will an M1 style GI web sling fit a 16" bbl M4 or is it too long?
I'm just wondering if I can tighten the M1 sling up and not have a long piece left sling over from the tightening.
couldnt you always just trim the tail off to make it neater?
Were you a marine also? HahaUse a lighter, and melt webbing. It'd be way more tactical that way too; no shiny metal clanking around....
Will an M1 style GI web sling fit a 16" bbl M4 or is it too long?
Use a lighter, and melt webbing.
The M1 sling is made out of cotton.
*tightened so that with a magazine inserted the sling was perfectly taut and had no slop when the receivers were closed.
The M1 style that has been used on ARs are also available in nylon. Like the nylon web sling shown in post #8.
Id avoid nylon slings if you're planning on using the sling for target shooting support. Nylon slips and it stretches. Stick with cotton
Back when I was in there were still a few M1 slings laying about. You could get them tight enough to make a parade sling* with one, would that be tight enough?
Id avoid nylon slings if you're planning on using the sling for target shooting support. Nylon slips and it stretches. Stick with cotton
Maybe?
Here's a web sling on my mid-length 16" barrled AR. With the original adjustable stock and with the current A1 stock. The A1 rear sling mount actually has a shorter reach than the fully extended adjustable stock.