1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Glock 31 with g22 barrel, case issue???

Discussion in 'Handguns: Autoloaders' started by jamesr, Jul 29, 2008.

Thread Status:
Not open for further replies.
  1. jamesr

    jamesr Member

    Aug 20, 2007
    From my understanding the extractor, mag, and everything is the same between the 31 and 22 models. So I got a glock factory g22 barrel, and shot 100 or so rounds yesterday at the range to test it out. It went through without a hitch, but for when I was picking up the brass I noticed a mark on the top and a slight dent.

    Any ideas, is this an issue? If the extractor, and Mag is the same do g22 mark their cases like this?

  2. M4inCA

    M4inCA Member

    Aug 19, 2007
    The extractor is the same, but the mags do have a slight difference.

    Have you checked the case from mag to chamber? Meaning, load from the mag to the chamber, but don't fire it. Take the round out and inspect it.

    If there is no damage from mag to chamber, then I would check for interference issues when the round is ejected.
  3. CountGlockula

    CountGlockula Member

    Oct 1, 2006
    In a Los Angeles coffin.
    Most likely those are teeth marks from your .40S&W mags. Try .357SIG mags next time.

    I'm also planning to purchase a G32 Glock barrel for my G23.
Thread Status:
Not open for further replies.

Share This Page