Quantcast

Got my Mossberg 590 Mariner, went shooting, small problem...

Discussion in 'Shotguns' started by Userzero, Oct 22, 2006.

Thread Status:
Not open for further replies.
  1. pezo

    pezo Member

    Joined:
    Nov 28, 2004
    Messages:
    765
    Location:
    Michigan
    This thread may turn useless now as it turns into a mossy versus remmy debate. AGAIN :banghead:
     
  2. PT92

    PT92 Member

    Joined:
    Aug 16, 2007
    Messages:
    1,174
    Location:
    Show Me State
    Not sure on the Mossberg's but I have had similar problems with Remington's and I had to polish the chamber (fired/swollen shells).

    -Cheers
     
  3. Carl N. Brown

    Carl N. Brown Member

    Joined:
    May 10, 2005
    Messages:
    8,689
    Location:
    Kingsport Tennessee
    I suspect the biggest problem is with rough chambers (from marine coat, dull chrome, applied coatings, etc), tight tolerances and the steel/aluminum head "bargain" shells.
     
  4. rustcat

    rustcat Member

    Joined:
    Jan 26, 2010
    Messages:
    14
    Location:
    DFW
    some of the cheap Winchester low base shells visibly expand and like to stick in my chamber sometimes. i dissected a few of the culprit rounds and noticed the plastic hull was noticeably thinner in those, causing them to swell.
     
  5. winchester '97

    winchester '97 Member

    Joined:
    May 20, 2009
    Messages:
    306
    Polish the living hell out of the chamber with a dremel and then try it.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice