Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

GP100 speedloader question.

Discussion in 'Handguns: Revolvers' started by madwell, Oct 28, 2010.

Thread Status:
Not open for further replies.
  1. madwell

    madwell Member

    Joined:
    Nov 6, 2008
    Messages:
    143
    Location:
    AZ, Phoenix
    Does anyone now if Safariland comp III speedloaders will clear Houge rubber grips on a GP100. I am going do an ICORE match in November and the organizer is letting me borrow some comp III's. I read a little about them online, and it says they can have clearance issues with some grips.

    Thanks
     
  2. rich642z

    rich642z Member

    Joined:
    Jan 20, 2007
    Messages:
    296
    Houge grips these days have been thinned down more so the HKS speedloader will work on anytype of a Houge grip. Maybe you should take your revolver to your LGS and check to see if they work with the grips.
     
  3. GP100man

    GP100man Member

    Joined:
    Mar 16, 2007
    Messages:
    1,749
    Location:
    Tabor City, NC.
    Nope , there just a little bit too thick , but I use HKS loaders .

    The best grips I`ve found for speed are the factory panel grips .

    JMHO YMMV

    102_0333.jpg
     
  4. madwell

    madwell Member

    Joined:
    Nov 6, 2008
    Messages:
    143
    Location:
    AZ, Phoenix
    GP100MAN: do the factory panel grips work with the Comp III's
    If they do I'll just buy some. My gun came with the Houges, but I wouldn't mind switching if the panel grips work with more speed loaders.
     
  5. GP100man

    GP100man Member

    Joined:
    Mar 16, 2007
    Messages:
    1,749
    Location:
    Tabor City, NC.
    Never used the compIIIs , work good with HKSs though.

    The only difference is the compIII ya push it to release the cases ????

    If there as thin on the rims as a HKS they should work .
     
Thread Status:
Not open for further replies.

Share This Page