Grips- Source for G-10 ?

Status
Not open for further replies.

Zak Smith

Member
Joined
Dec 24, 2002
Messages
9,174
Location
Fort Collins, CO, USA.
I am going to have some custom grips made for a couple of my pistols. I want them to be made out of G-10, a composite material often used for knife handles (e.g. Benchmade 730) and pistol grips (e.g. Simonich's Gunner Grips), though it is most often used in the printed circuit board industry.

Does anyone know of a good source for smallish G-10 blocks, which I could send to the guy making my grips?

thanks
Zak
 
yes, better than adequate ventilation is required and you'll probably find it pretty tough stuff to work with. But it sure looks cool... Here's my BlindHogg raw G10 grips.

SSSpringfield3.jpg


SSSpringfield4.jpg
 
Status
Not open for further replies.
Back
Top