Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hard Cast (Missouri 150 gr) in rifles

Discussion in 'Handloading and Reloading' started by kestak, Sep 11, 2010.

Thread Status:
Not open for further replies.
  1. kestak

    kestak Member

    Joined:
    Jul 22, 2007
    Messages:
    1,345
    Greetings,

    I have been shooting only jacketed bullets in my rifles. I would like to shoot more my 30-06 savage 110 (bolt-action). How would be the accuracy and lead fouling if I try Missouri hard cast bullets?

    Using hard cast bullets, would it save also my rifle barrel like it does with pistol barrels. I am at about 50,000 rounds in my 9mm pistol and the barrel is still going strong.

    Last question, would I be able to use the same rifle powders or will I have to use a powder like Unique?

    Thank you
     
  2. velocette

    velocette Member

    Joined:
    Jan 21, 2008
    Messages:
    690
    Location:
    Ft. Lauderdale Fla
    The Missouri bullets, excellent as they are, are not hard enough for rifle use. Further they are not designed for use with a gas check which is essential for success with lead bullets in a modern rifle. If you were shooting a 30-30 with pistol powders, perhaps but your '06 has a lot more case capacity than a 30 30.
    Perhaps you might contact Missouri and ask them about a gas check or advice.
    They are really good folks there and really care about their customers.
    In any event pistol powders such as Hodgdon Universal or Alliant Unique are in the range needed for your goals.
    Roger
     
  3. Chuck Perry

    Chuck Perry Member

    Joined:
    Dec 27, 2002
    Messages:
    895
    Location:
    Pittsburgh,PA
    I have read several articles promoting the use of Trail Boss for cast bullets in centerfire rifle cartridges. Moderate veolocity with good accuracy, low recoil, and the stuff is pretty much idiot proof to load with.
     
  4. Gadzooks Mike

    Gadzooks Mike Member

    Joined:
    Mar 7, 2009
    Messages:
    411
    It's not the velocity, it's the pressure. With MB boolits, you can push them up to around 23,000 psi. Now all you have to do is find a powder that will give you a decent velocity (or what you're trying for, anyway) that doesn't exceed that pressure. I'm shooting 30-30 loads right at 1800 fps with MB rifle boolits. Any other story you hear means somebody isn't doing their homework and are just relying on old wives' tales.

    In other words, a proper load will do exactly what you want, as long as you're not expecting to sling lead at 3000 fps. You've got to do the math first.
     
  5. qajaq59

    qajaq59 Member

    Joined:
    Dec 7, 2005
    Messages:
    2,375
    Location:
    S. C. Florida
    I think a call to MB would likely take care of what you want to do. They're pretty swift over there.
     
Thread Status:
Not open for further replies.

Share This Page