Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Has anyone used RCBS lock out die for rifle loads?

Discussion in 'Handloading and Reloading' started by IMtheNRA, Feb 20, 2008.

Thread Status:
Not open for further replies.
  1. IMtheNRA

    IMtheNRA Member

    Joined:
    Dec 24, 2002
    Messages:
    1,121
    The instructions say that it is for straight-wall pistol cartridges only, but I was wondering if anyone has figured out a way to use it for bottle neck rifle loading. I'm not worried about double charges there, but would like to guard against empty cases.
     
  2. DaveInFloweryBranchGA

    DaveInFloweryBranchGA Member

    Joined:
    Dec 7, 2005
    Messages:
    1,539
    Location:
    NE Georgia
    IMtheNRA,

    The problem you'd run into is the RCBS lockout die has a nylon "tip" that slips into the case on top of the powder. You wouldn't have one for rifle cartridges and I'm not sure if the "rod" inside the die is long enough for rifle. I think you might be better off looking at a Dillon powder alarm in that case, though I'm not sure if they handle rifle cartridges or not, since I simply look at mine with a visual check and a good light.

    I typically run about 400 30.06 or other rifle cartridges an hour going slowly on my Lock N Load while doing a visual powder check on each case.

    Dave
     
Thread Status:
Not open for further replies.

Share This Page