Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Headspace - What the heck is it?

Discussion in 'Rifle Country' started by Werewolf, Feb 16, 2005.

Thread Status:
Not open for further replies.
  1. Werewolf

    Werewolf Member

    Joined:
    Sep 12, 2003
    Messages:
    4,192
    Location:
    Oklahoma
    See Subject:

    I remember in Army Basic way back 34 years ago them telling us about setting headspace and timing on the M2 .50 cal but since I was gonna be a tanker I pretty much ignored the demonstration and the .50's we had on our M-60 tanks we didn't have to worry about that stuff.

    Now I see headspace mentioned very frequently here and how if it's off nasty things can happen. I see that it is measured in different ways and from different points depending on the cartridge.

    So could someone who is knowledgeable please provide an explanation of what headspace is, what it does and the ramifications of it being wrong.

    Inquiring minds wanna know...
     
  2. musher

    musher Member

    Joined:
    Jan 4, 2003
    Messages:
    586
    Location:
    Fairbanks, AK
    heh heh, do a search and you'll get all kinds of entertaining reading about headspace.

    If I had to define it off the cuff I'd say it is the distance measured from the face of the closed breech to a datum on the specific cartridge you're working with. That datum varies from cartridge to cartridge, and could be the middle of the shoulder, rim of the cartridge, the belt, the rim or ...??

    Measurement on a particular gun is done using precisely machined gauges (headspace gauges). They come in a bunch of different varieties for each cartridge, but your basics are go and no go. Simplified, if the bolt will close on a go but not on a no go gauge, your headspace is within specs. Some guns require removal of things like extractors from the bolt to get a good measurement.

    Headspace is there, because we need a little slop in the machine for cartridges to move in and out of the chamber w/o undue friction. Too little headspace, and you'll have problems closing the bolt on some cartridges.

    Too much headspace allows the brass to expand more than designed. In severe cases, it may rupture, venting gases back into the action.

    I probably got a lot of this wrong, but I think the basics are correct and sooner or later, someone will wander by to correct my errors.
     
  3. Mr. Mysterious

    Mr. Mysterious Member

    Joined:
    Dec 21, 2003
    Messages:
    665
    Location:
    Indianapolis
  4. Werewolf

    Werewolf Member

    Joined:
    Sep 12, 2003
    Messages:
    4,192
    Location:
    Oklahoma
    Thanks guys. One is never too old to learn something new.
     
Thread Status:
Not open for further replies.

Share This Page