Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help! Glock slide blocked

Discussion in 'Gunsmithing and Repairs' started by mwsenoj, Mar 29, 2013.

Thread Status:
Not open for further replies.
  1. mwsenoj

    mwsenoj Member

    Joined:
    May 13, 2011
    Messages:
    310
    Location:
    The desert
    Said as much as I could think of when I took the video. Please watch and diagnose and suggest remedy if you can.

    This happened when I was installing the Ghost Rocket 3.5 connector. It happens the same when the connector is in or not. Also the same when the bbl and spring are in place or removed.

    http://youtu.be/8fozPngtZpo
     
    Last edited: Mar 29, 2013
  2. mwsenoj

    mwsenoj Member

    Joined:
    May 13, 2011
    Messages:
    310
    Location:
    The desert
    It looks like this will remain a mystery because whatever the problem was has wiggled itself back into spec. Looking forward to trying it out tomorrow.
     
  3. kyhunter

    kyhunter Member

    Joined:
    Feb 21, 2013
    Messages:
    285
    Location:
    western ky
    did you remove the slide lock? if so was it reinstalled backwards? Also double check to make sure the recoil spring is in its slot on the barrel.
     
    Last edited: Mar 30, 2013
  4. SilentScream

    SilentScream Member

    Joined:
    Oct 17, 2004
    Messages:
    266
    Location:
    Columbus Ga
    I would make sure the ejector assembly is seated correctly as I noticed the rear pin was out of the frame.
     
  5. AKpwnr

    AKpwnr member

    Joined:
    Apr 4, 2013
    Messages:
    3
    Hard to tell from the video, you've probably already done it but I would dissasemble everything, inspect every part then put it back together, it seems to solve 90% of my firearm problems.
     
Thread Status:
Not open for further replies.

Share This Page