Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

help needed to designe telescope rings

Discussion in 'Shooting Gear and Storage' started by engineeerr, Jul 14, 2010.

Thread Status:
Not open for further replies.
  1. engineeerr

    engineeerr Member

    Joined:
    Feb 20, 2010
    Messages:
    6
    Location:
    islamabad pakistan
    heya m new in here i am looking for design of rifle telescope rings with which i can fire with normal sights and telescope both. can some one help me.
    engineer nadeem
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    See-Through rings are widely available at low prices from many manufactures.

    http://www.cabelas.com/cabelas/en/t...710601&cm_ite=0054164711879a&_requestid=43279

    http://www.combathunting.com/SCOPE_RINGS-Scope_Rings_1_Weaver_Style_See_Through_3.html

    http://www.amazon.com/gp/product/B0..._m=ATVPDKIKX0DER&pf_rd_r=1C5HVWP78CJEXGSKZJV0

    In actual practice, it isn't such a good idea as it might seem.

    They raise the scope way above where it would normally be low mounted closer to the bore line.
    So, you have to hold your head up off the stock to see through the scope and lose a good cheek weld necessary for accurate shooting.

    The high sight line also changes the trajectory of the bullet, and you will find normal hold over or under not working like it does with the open sights on the barrel, or a low mounted scope.

    In addition, modern scopes are so reliable it is very unlikely one is going to break and make the use of iron sights necessary anyway.

    rc
     
  3. engineeerr

    engineeerr Member

    Joined:
    Feb 20, 2010
    Messages:
    6
    Location:
    islamabad pakistan
    thank you
     
Thread Status:
Not open for further replies.

Share This Page