Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HELP! Scope Adjustments Bottoming out

Discussion in 'Rifle Country' started by CARSON, Mar 23, 2003.

Thread Status:
Not open for further replies.
  1. CARSON

    CARSON Member

    Joined:
    Feb 4, 2003
    Messages:
    49
    Location:
    Nepean, Ontario
    I just bougt a used Baush and Lomb Elite 4000 last week. I mounted on a rifle that had previously had a scope on it that adjusted correctly. I mounted this scope in the same rings and bases (Ruger #1) that the other was in and took it to the range. I tried sighting it in at 50 yards, but it was hitting 1 foot too high, and it hit center with the adustment all the way to the right.


    I am trying to determine if it is a problem with the scope or not. If it is, a mighttry to get it repaired. If it is the mounts, can anyone tell me how to solve this problem? Any help is much appreciated.
     
  2. uglymofo

    uglymofo Member

    Joined:
    Jan 4, 2003
    Messages:
    429
    Location:
    PRK
  3. cratz2

    cratz2 Member

    Joined:
    Dec 24, 2002
    Messages:
    4,233
    Location:
    Central IN
    Sounds pretty unusual for a Ruger with Ruger rings... they usually work out pretty well. ;)

    Only time I've had a problem like that, one of the mounts (rear one, I think) was slightly mis machined by the manufacturer.
     
  4. Al Thompson

    Al Thompson Moderator Emeritus

    Joined:
    Dec 21, 2002
    Messages:
    8,847
    Location:
    South Carolina
    Sounds like the scope to me. If you had one that worked and this one does not, then I can't see a problem with the rings or rifle.

    What kind of scope did you use previously?

    Do you have another scope you could use to verify that the rings/rifle is OK?

    Also - you mentioned that the adjustment is bottoming out. Did you use all the windage adjustment when you got it on target or do you have some more left?
     
  5. goon

    goon Member

    Joined:
    Jan 20, 2003
    Messages:
    7,251
    I had a similar problem with a Savage 10FP that I used to have.
    When I got the gun home, the scope was perfectly zeroed...
    at about 1100 yards.
    I adjusted the scope as low as it would go, but it was still shooting about 40 inches high at my improvised 150 yd range.
    I took it back to the shop that I bought it from.
    All they did was tap the scope a few times, then boresight it.
    They told me that the crosshairs on just about any scope can seize up if it is adjusted too far, and you just have to bump it to break them loose.
    I have since heard that this even happens with Leupold scopes.

    When I say bump, I just mean a little, but solid rap with your knuckles. Don't go banging on it with a hammer or something.

    If something is crooked with the mounts, you will probably be able so see that it is out of square.
     
Thread Status:
Not open for further replies.

Share This Page