Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help w/ failure to extract

Discussion in 'Handguns: Autoloaders' started by conw, Apr 12, 2008.

Thread Status:
Not open for further replies.
  1. conw

    conw Member

    Joined:
    Aug 17, 2007
    Messages:
    3,364
    Yesterday I was shooting my P11 and it stopped extracting completely. Can't get it to extract snap-caps manually when I rack the slide they just sit in the extractor and go back in the chamber. I am afraid to use live rounds now.

    Any suggestions would be really helpful. Thanks a lot.
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    P11 as in Kel-Tec P-11?

    If so, your ejector is broken.

    (It is extracting if it pulls the case out of the chamber, holds it, and puts it back in.)

    Part #115 in the drawing.
    http://www.kel-tec-cnc.com/p11parts.html

    Call them and they will send you one free.
    1-800-515-9983 and ask for service dept.

    rcmodel
     
  3. conw

    conw Member

    Joined:
    Aug 17, 2007
    Messages:
    3,364
    Thanks for the tip. I took it by a local gun shop and the 'smith said it was snapped clean off.

    rcmodel or anyone, know how hard it will be to install myself? I am ok at putting stuff back together, if it isn't "advanced" I should have it covered.

    Kinda makes me mad though. But at least I don't have to send the gun off for weeks.
     
  4. JDGray

    JDGray Member

    Joined:
    Sep 16, 2005
    Messages:
    5,129
    Location:
    SW MI.
    I replaced mine, without taking it compleatly apart. It was pretty basic. Call KT, they will send you a replacement, or two:D
     
  5. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
Thread Status:
Not open for further replies.

Share This Page