Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

help with ruger MKIII and 22/45

Discussion in 'Handguns: Autoloaders' started by WampusCat79, Jul 10, 2012.

Thread Status:
Not open for further replies.
  1. WampusCat79

    WampusCat79 Member

    Joined:
    Jul 10, 2012
    Messages:
    3
    I have a pair of ruger 22s, one a target barreled 22/45, the other a light barreled reciever on a steel frame. I tried swamping the frames and have found that the front lugs need to be adjusted. I can see that the lugs are not part of the frames, but are embeded pillars. Any help would be good, thanks.
     
    Last edited: Jul 10, 2012
  2. JDGray

    JDGray Member

    Joined:
    Sep 16, 2005
    Messages:
    5,129
    Location:
    SW MI.
    No swapping on those...

    Welcome to THR!
     
  3. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    +1

    There are fitted at the factory to be tight and stay tight.

    They shouldn't be swapped.

    rc
     
  4. JDGray

    JDGray Member

    Joined:
    Sep 16, 2005
    Messages:
    5,129
    Location:
    SW MI.
    The bolt release on the 22/45 is in the way if I remember correctly. Tried putting my Stepdads MKII upper on my 22/45 lower years ago, and remember it was a nogo.
     
  5. WampusCat79

    WampusCat79 Member

    Joined:
    Jul 10, 2012
    Messages:
    3
    thanks for your replies
     
Thread Status:
Not open for further replies.

Share This Page