Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hornady Case Feeder Help - Cam Wire

Discussion in 'Handloading and Reloading' started by Uncle Richard, Aug 5, 2013.

Thread Status:
Not open for further replies.
  1. Uncle Richard

    Uncle Richard Member

    Joined:
    Jan 1, 2012
    Messages:
    324
    Location:
    WV
    I need help with the cam wire and wire guide for the Hornady Case Feeder. Specifically, the wire is to short and doesn't stay inside the guide because additional threading was added to lower the cam wire. This was done because not enough adjustment was available to properly time the sequence of the slide with the shell plate (as seen in another post). Now the timing is perfect but the cam wire is to short and barely fits in the wire guide.

    Does anyone have a modification that fixed the short wire (i.e., modified guide, weld extension to wire, etc). Would appreciate any suggestions. Pictures would be helpful.

    Thanks in advance.
     
    Last edited: Aug 6, 2013
  2. Uncle Richard

    Uncle Richard Member

    Joined:
    Jan 1, 2012
    Messages:
    324
    Location:
    WV
    No replies necessary.

    Called Hornady Customer Service (spoke with Lonnie) and Hornady now makes a longer cam wire (part number 398299). Should have the part by the end of the week and didn't cost me a dime.

    Hornady has great customer service. Time and time again, I have never been disappointed.
     
    Last edited: Aug 6, 2013
Thread Status:
Not open for further replies.

Share This Page