I picked up a S&W model 66

Status
Not open for further replies.
G

Gixerman1000

Member
Joined
May 22, 2004
Messages
568
Location
Eastern USA
I have been thinking about a buying a model 66 for a while but kept putting it off, well I found one that really caught my eye and I just had to bring it home.

It’s a 3” Satin stainless 66-4 with factory mag-na-porting and wood grips

BU1SW66.jpg

BU2SW66.jpg

BU3SW66.jpg
 
Last edited:
Thanks

It was $525 and I ended up paying $450, it was a limited run and I don’t think that S&W made very many so I lucked out being in the right place at the right time.
 
The grips are stock, it came from a limited run of 500 or so made for RSR Distributors in 1996 and was shipped as shown.
 
Hey Gixerman, really nice piece. Have you noticed any flash or smoke from the Magna-Port?¿

I bought a used 66 in 3" this spring, it's a dash 4 also. Firing pin is on the hammer and NO LOCK. :) It came w/ some unattractive black grips which promptly got replaced with some wooden Hogues. It's scary accurate--either DA or SA. Wife shoots it real good too.

I have digital pics of mine. I'd post a picture, but don't know how to do that part yet. Any place on this site that walks one thru the picture posting process? (And I do mean step-by-step)
 
Gixerman, just noticed from looking at your pictures again that your 66 has a steel front sight blade (which would make sense w/ the Magna-Port). My 3" has the red/orange front blade plastic insert.
 
Status
Not open for further replies.

Similar threads

1
  • Locked
Is there a "best" model 66 ?
Replies
13
Views
1K
colubrid
C
G
  • Locked
Smith & Wesson 66-2 vs. 66-8: Question about grips
Replies
3
Views
847
Pudge
Pudge
G
  • Locked
S&w 66
Replies
11
Views
725
Olympus
Olympus
O
  • Locked
S&W model 66
Replies
9
Views
724
ShooterMcGavin
S
F
  • Locked
S&W model 19 or 66?
Replies
18
Views
772
Fishslayer
Fishslayer
Back
Top