Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

I want a 625 4inch.

Discussion in 'Handguns: Revolvers' started by Brian Williams, Nov 3, 2004.

Thread Status:
Not open for further replies.
  1. Brian Williams

    Brian Williams Moderator Emeritus

    Joined:
    Dec 22, 2002
    Messages:
    9,863
    Location:
    Kampong Cham, Cambodia
    I am looking for a S&W 625 with a 4" barrel. I would rather have a 25, but there are not many 4" 25's out there. I would prefer a fixed sight gun but...

    I have to settle for a Adjustable sight gun and probably stainless.

    Requirements/Specs
    4" barrel
    45 caliber, I reload for both ACP and Colt
    Round butt would be nice
    Prefer Hammer based firing pin
    NO MIM
    No lock
    Moonclips
    Grips can be changed.

    What model do you have and/or recommend.

    I am jonesin for a large bore moonclip gun.
     
  2. Majic

    Majic Member

    Joined:
    May 3, 2003
    Messages:
    5,370
    Location:
    Virginia
    4 inch Model 25s were made chambered in .45 Colt, but they don't use moonclips. The most common is the Model 25-5.
     
  3. Bill B.

    Bill B. Member

    Joined:
    Jun 25, 2004
    Messages:
    961
    I have the 625 Mountain Gun in 45 ACP. It is one of my favorite revolvers! I think from what I have read on the S&W forum that even my 625 has MIM parts even though it is prelock. From what I have seen posted over on that forum it is much easier to find one in 45LC than in 45 ACP. There are several looking for the 45 ACP version over there at present so if you find one available you may wish to purchase rather quickly! These are some very accurate and reliable revolvers.
     
Thread Status:
Not open for further replies.

Share This Page