Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Installing Non-Pinned Barrel in a 29-2?

Discussion in 'Handguns: Revolvers' started by bluetopper, Mar 27, 2010.

Thread Status:
Not open for further replies.
  1. bluetopper

    bluetopper Member

    Joined:
    Dec 17, 2005
    Messages:
    3,221
    Location:
    Northeast TX
    I've found a 3" non-pinned barrel and I'm thinking of installing it in my 29-2.

    What modifications do I have to make and is it worth the trouble?

    Thanks......
     
  2. Oro

    Oro Member

    Joined:
    Sep 22, 2007
    Messages:
    3,496
    Location:
    WA state
    Yes, it certainly can be done.

    Any machinist/gunsmith who is skilled and equipped enough to be able to trim the shoulder and forcing cone can certainly add a cut to enable re-installation of the pin, even if it's not entirely necessary. It would just look wrong with the two empty pin holes in the frame!
     
  3. bluetopper

    bluetopper Member

    Joined:
    Dec 17, 2005
    Messages:
    3,221
    Location:
    Northeast TX
    So just making a notch in the threads for the pin to go through is all that has to be done?
    Maybe carefully done with a tiny round hand file?
     
  4. Oro

    Oro Member

    Joined:
    Sep 22, 2007
    Messages:
    3,496
    Location:
    WA state
    It doesn't really even have to be done - that would just be a small step that would look nice. S&W was crush-fitting barrels from the early '50s onward. They were just very slow in deleting the pin. The gunsmith can crush fit the barrel without the pin; it would just look odd since the frame is drilled.
     
  5. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    No.

    As Oro said in post #3, the shoulder and barrel shank will have to be lathe turned and fitted to the frame so it lines up with the sight on top and the barrel/cylinder gap set correctly. Then the forcing cone will have to be recut.

    The chance of it just screwing on and fitting is very slim.
    Especially if it has already came off of another gun and already been fitted to that frame.

    rc
     
  6. Zundfolge

    Zundfolge Member

    Joined:
    Dec 24, 2002
    Messages:
    10,755
    Location:
    Colorado Springs
    rcmodel is correct.

    I looked into this same thing with my 29-2 a couple years ago (only the barrel I found was a 2.5" 629 barrel) and was basically told by a gun smith that it would be easier, cheaper and I'd get a better result if I just had the barrel on my 29-2 cut down, recrowned and the sight moved back.
     
  7. bluetopper

    bluetopper Member

    Joined:
    Dec 17, 2005
    Messages:
    3,221
    Location:
    Northeast TX
    No, I don't want to cut and recrown my 6" barrel. I want the option of installing my original barrel back.

    I've already clicked on "Buy It Now" on the 3" barrel, so we'll see what transpires.;)

    I've wanted a snub 44 for a while and I think the value of my 29 will be increased more than the price I'm paying for the barrel.....not that I will have any intention of selling it.
     
Thread Status:
Not open for further replies.

Share This Page