1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.


Discussion in 'Rifle Country' started by GD, Mar 15, 2008.

Thread Status:
Not open for further replies.
  1. GD

    GD Member

    Dec 26, 2002
    Picked up my 2nd K31 at the Wichita show last weekend. This one is walnut stocked and has a mint bore. Got to try it out this week and my first two shots at 110 yards were both bulleyes! After that each round shot went an inch lower. After cooling down, the rifle again hit bullseyes. I used GP11 ammo. Is this common on the K31? BTW, I got the rifle for $125, sling included.

    Attached Files:

    • k31s.JPG
      File size:
      111.8 KB
  2. jrfoxx

    jrfoxx Member

    Sep 23, 2004
    Not that I've really ever heard of, I know mine is pretty consistant and doesnt do that.Possible some of the screws are too loose, or too tight, and when it heats up a little, the barrel or part of he receiver makes partial contact with the stock messing it up.Thats probly what I'd look at first,is the screws If they seem ok, see if the handard is just lightly touching the barrel anywhere, causing the same problem when it gets hot. Might be a small spot in the barrel channed that expanded a little at some point, and is just barely touching, and as it heats up, it presses harder and harder on the barrel.See if a dollar bill will slide under the barrel the whole length, if not, lightly sand the spots its touching until it does, and that should certainly help out.I'm told these can be kinda sensitive to any touching since they were designed to not make contact at the barrel (the other choice is to bed the whole thing.I'm told either works well, as long as the pessure, or lack of, is the same everywhere, our good to go.) Never experianced ayn of this peronally, but this is what I have read an been told, and it seeems to make perfect sense to me, and seems like a likely cause of the way it was acting on you, IMHO.

    If I'm way of base here,I'm sure one of the may k31 lovers here will straighten it out though.By the way, REALLY great price for a k31.They have steadily been getting pricier and pricier the last couple years.Good job.They seem to be averaging closer to $175-$200 last I looked.
  3. Soybomb

    Soybomb Member

    Oct 31, 2005
    The K31 does NOT have a floating barrel although with as well as most of them shoot, its understandable why people would think that :D

    Check out this link http://www.swissrifles.com/sr/pierre/accurizing.html and read through it. Also check out the forums here http://theswissriflesdotcommessageboard.yuku.com/forums/5/t/Straight-Pull-Rifles.html and read about what other have tried. Some people have sanded on their stock to get a float and were pleased with the results. Others wound up with a gun that shot worse than before. Save the sand paper for until you're 100% you know what you're doing :)
  4. Navy joe

    Navy joe Member

    Dec 24, 2002
    No sandpaper required. Take the stems of Q-tips(the rolled paper kind) and place between upper and lower handguards at forward barrel band. Re-tighten forward band. Should relieve most of the pressure.
Thread Status:
Not open for further replies.

Share This Page