Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kel-Tec Trigger Shoe

Discussion in 'Handguns: Autoloaders' started by jondar, Nov 21, 2006.

Thread Status:
Not open for further replies.
  1. jondar

    jondar Member

    Joined:
    Jun 10, 2005
    Messages:
    481
    I am about to order one of these for my P-11, anyone know the most reasonable place to buy one? Also reading a post regarding putting one of these on a P3-AT the poster cautioned that material must be removed from both edges, in that as it comes it will be "wider" than the trigger guard on the .380. Would this hold true for the P-11, or does it have a "wider" trigger guard? Thanks for any help.
     
  2. alamo

    alamo Member

    Joined:
    Dec 27, 2002
    Messages:
    1,219
    Location:
    austin, texas
    It works just fine on the P-11, no mods needed.

    This is useful. I would recommend steps 1, 2. I did those and then used some Loctite on the screws. It has stayed on but it can be removed if needed.

    http://www.ktog.org/tecwerks8.htm
     
  3. jondar

    jondar Member

    Joined:
    Jun 10, 2005
    Messages:
    481
    Alamo - Which LocTite did you use, the blue or the strong stuff? I had planned on using some of my wife's clear nail polish but LocTite's probably better.
     
  4. alamo

    alamo Member

    Joined:
    Dec 27, 2002
    Messages:
    1,219
    Location:
    austin, texas
    I can't recall the color. I know it wasn't the strong stuff so maybe I used the blue if that is the milder version.
     
Thread Status:
Not open for further replies.

Share This Page