Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kim Ahrends does great work (S&W Model 28 grips)

Discussion in 'Handguns: Revolvers' started by 1KPerDay, Feb 28, 2010.

Thread Status:
Not open for further replies.
  1. 1KPerDay

    1KPerDay Member

    Joined:
    Jan 19, 2006
    Messages:
    12,684
    Location:
    Happy Valley, UT
  2. joe_security

    joe_security Member

    Joined:
    Apr 22, 2007
    Messages:
    480
    While the grips were off you could have: Oiled the rebounding hammer /spring, and the coil spring that powers the hammer. Use a needle oiler for this. It doesnt take much oil, only a drop on each. Not to be too critical but the finish on those beautiful Ahernds grips will last quite a bit longer if you dont slide them across the workbench like that. The same goes for the Model 28.
     
  3. 1KPerDay

    1KPerDay Member

    Joined:
    Jan 19, 2006
    Messages:
    12,684
    Location:
    Happy Valley, UT
    The finish on the table is very smooth, but I'll be more careful in the future. The hammer spring is not a coil spring on this model BTW.

    I'd like to do a S&W disassembly/reassembly video if you have any input or advice. :cool:
     
  4. joe_security

    joe_security Member

    Joined:
    Apr 22, 2007
    Messages:
    480
    Silly of me...I forgot about the leaf spring...I guess I had J-frame on the brain !!! Nice grips, enjoy that classic wheelgun !
     
    Last edited: Feb 28, 2010
Thread Status:
Not open for further replies.

Share This Page