Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

kimger exlipse pro II minor challenge

Discussion in 'Handguns: Autoloaders' started by yz450, Mar 1, 2009.

Thread Status:
Not open for further replies.
  1. yz450

    yz450 Member

    Joined:
    Mar 1, 2009
    Messages:
    3
    I'm having trouble reasembling the slide stop on my new kimber. for whatever reason, it doesn't seem to fit. Any advice? Thanks in advance.
     
  2. shooter1

    shooter1 Member

    Joined:
    Jan 14, 2004
    Messages:
    1,048
    Location:
    In the shadows.
    If the barrel link is properly aligned with the hole in the slide it should slide right in. Assuming the slide stop notch is also properly aligned to allow the SS to snap in place. Check your manual and be sure you're assembling your Kimber properly. Don't force anything, it should go together without excessive force.
    str1
     
Thread Status:
Not open for further replies.

Share This Page