Kydex repair

Status
Not open for further replies.
Joined
Jun 26, 2004
Messages
934
Location
Central Kentucky
My comp-tac CTAC snapped on me a couple of days ago, the forward belt clip broke in two at the top. I've been trying to think of a good way to repair it without having to buy a new clip. I bought some 'industrial' strength epoxy at the store, but I don't think it's going to bond at all. I didn't think something like j.b. weld would either.

So does anyone know any cements/epoxies that will bond kydex? Or am I going to have to order a whole new clip?
 
I do not have an answer for you. I have one Kydex holster and have hardly used it. But I will speculate and say that once this stuff breaks, you may as well toss it and get a new one. Even if you find a cement that bonds it, it is going to be a liability, not knowing when this battlefield repair is going to give again.

How old is it, and have you contacted the maker?

--------------------------------------

http://ussliberty.org
http://ssunitedstates.org
 
I've been watching this post

My first reaction when I read this post yesterday was use JB Weld and clamp it down overnight but ... a holster is something that you bet your life on, which certainly merits a new holster.

And yeah, I agree with LAK ... contact the maker of the holster he might replace it for you at no cost.

http://www.bearclawholsters.com
http://www.predator-holsters.com
http://www.hillsmanholster.com

The above use thermo-formed kydex which is far superior to the injection molded stuff mass produced by Fobus and Uncle Mike ... might be worth a look.

Best regards,

lance22
Minn Uh So Tah
 
Wanted to let folks know that I have emailed comp-tac and they promptly replied that they would go ahead and mail me some replacement clips. Good on them! Nice to see simple customer service.
 
Status
Not open for further replies.
Back
Top