Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

LCT Auto Index

Discussion in 'Handloading and Reloading' started by aerod1, Jan 31, 2013.

Thread Status:
Not open for further replies.
  1. aerod1

    aerod1 Member

    Joined:
    Feb 26, 2003
    Messages:
    973
    Location:
    Garland, TX
    Does the square ratchet inside the
    Auto index clamp go in with the
    raised side up or down? Thanks
     
  2. bengals1975

    bengals1975 Member

    Joined:
    Jan 23, 2013
    Messages:
    32
    I'm a little confused by the question but let me try to answer it anyway :)

    the indexing rod has one end with a square nut on the end and another end that's twisted. the twisted end goes at the bottom, square end goes into the turret. It may take some twisting of the turret to get it to settle into position, and I've found raising the cylinder (lowering handle) often helps with this (it disengages the cylinder from the twisted part and enables it to turn).

    Hope this helps.
     
  3. ljnowell

    ljnowell Member

    Joined:
    Jun 21, 2008
    Messages:
    6,193
    Location:
    The Peoples Republic of IL
    He is talking about the square plastic ratchet at the bottom, not the metal square at the top.

    OP I have installed them both ways, never noticed a difference.
     
  4. RustyFN

    RustyFN Member

    Joined:
    Jul 5, 2006
    Messages:
    3,170
    Location:
    West Virginia
    I'm pretty sure it goes with the wide part on top.
     
Thread Status:
Not open for further replies.

Share This Page