Quantcast

Length of Cyliner in ASM Walker's VS Uberti Walkers

Discussion in 'Blackpowder' started by Gaucho Gringo, May 14, 2010.

Thread Status:
Not open for further replies.
  1. Gaucho Gringo

    Gaucho Gringo Member

    Joined:
    Sep 10, 2006
    Messages:
    1,092
    Location:
    Vancouver, WA
    Hi. I was wondering if the length of an ASM Walker cylinder is different than a Uberti Walker and if so the measured difference of the cylinder between the two. Thank you in advance.
     
  2. Pops

    Pops Member

    Joined:
    Mar 5, 2008
    Messages:
    67
    My ASM Walker cylinder measures 2.596"
    Got no Idea what a Uberti's is.
    023.jpg
     
  3. mykeal

    mykeal Member

    Joined:
    Sep 9, 2006
    Messages:
    5,147
    Location:
    Michigan
    I have both a Uberti and an ASM Walker; I can do that measurement and report back tomorrow night.
     
  4. Tommygunn

    Tommygunn Member

    Joined:
    Jun 14, 2006
    Messages:
    5,233
    Location:
    Morgan County, Alabama
    2.574" on my Uberti Walker cylinder.
     
  5. Oyeboten

    Oyeboten Member

    Joined:
    Mar 23, 2008
    Messages:
    3,696
    2.573 for my 'Uberti' WALKER Cylinder...


    2.592, for a WALKER Cylinder I have of unknown make.
     
  6. Gaucho Gringo

    Gaucho Gringo Member

    Joined:
    Sep 10, 2006
    Messages:
    1,092
    Location:
    Vancouver, WA
    Thanks to all who took the time to reply. The reason I was asking was I have a chance to buy a Walker .45 colt conversion cylinder that is for a Uberti and was wondering if it would or could be adapted to fit an ASM. Thank you.
     
  7. Oyeboten

    Oyeboten Member

    Joined:
    Mar 23, 2008
    Messages:
    3,696
    I would not bet on it...


    But, if it was a whole buncha reasonable, and you wanted to try it, if it did fit, you'd be happy, and, if it did not fit, ( high odds on that, if not a guarentee! ) you could sell it ( here, or on Gunbroker, ) to someone who has a Uberti, and not feel like you got left holding the Bag.
     
  8. mykeal

    mykeal Member

    Joined:
    Sep 9, 2006
    Messages:
    5,147
    Location:
    Michigan
    My Uberti Walker:
    2.566 overall (front of cylinder to top of ratchet teeth)
    2.433 front of cylinder to rear surface below ratchets

    My ASM Walker:
    2.557 overall
    2.436 front of cylinder to rear surface below ratchets.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice