Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Lever action safety issues

Discussion in 'Rifle Country' started by GIJOEL, Nov 21, 2010.

Thread Status:
Not open for further replies.
  1. GIJOEL

    GIJOEL Member

    Joined:
    Feb 5, 2010
    Messages:
    284
    Location:
    Milwaukee, WI
    Anyone know of model specific safety issues with lever action rifles? While at the cabin this weekend, there was a ND on the front porch that claimed 3 ceramic bowls and a cabinet. The rifle was cased immediately after the incident so all i know is that it was a 30-30 lever action. The owner was loading the rifle and claimed that there was no way that he could have tripped the trigger on accident. Could the primer get struck by part of the action on the way into the chamber? I know of issues with older models not having any safety other than putting the hammer down on a live round.
     
  2. R.W.Dale

    R.W.Dale Member

    Joined:
    Oct 14, 2005
    Messages:
    11,359
    Location:
    Northwest Arkansas
    Lowering the hammer after loading possibly on an older model?

    Cause pulling the trigger on a loaded, cocked and hot chamber to engauge the safety couldn't possibly be dangerous as later posters will try to point out.
     
  3. Tommygunn

    Tommygunn Member

    Joined:
    Jun 14, 2006
    Messages:
    4,465
    Location:
    Morgan County, Alabama
    Thing is, there are different .30-30 rifles and different designs are going to be susceptible to different problems.
    The one common problem all guns have in "going off" is having the trigger pulled.
     
  4. Malamute

    Malamute Member

    Joined:
    May 12, 2004
    Messages:
    2,980
    Location:
    Rocky Mts
    "...I know of issues with older models not having any safety other than putting the hammer down on a live round."


    Which models are you refering to? The only older lever action model I'm aware of that came without a half cock safty was the early Henry rifles, the ones made in the early 1860s. They started putting half cock notches in the hammers before they quit making the Henrys, and began building 1866 Winchesters (none of which were in 30-30 cal). Everything since then has had a half cock safety that I've heard of.

    Half cock safeties are relatively safe, so long as you don't touch the trigger when clearing the gun, or fumble setting the hammer to half cock after loading the chamber. I can't think of a good reason to load the chamber at the cabin, I only chamber a round when a shot is imminent.

    I don't know the person in question, but people make all sorts of claims right after they did something dangerous and unthinking. Guns rarely just "go off", unless they are mechanically damaged, such as a chipped sear or broken half cock notch. Otherwise they require a finger on the trigger.
     
  5. justgoto

    justgoto member

    Joined:
    Mar 23, 2009
    Messages:
    86
    "there was no way" speaks theoretically. He obviously knows if he did or didn't; there is no need to theorize. Dangerous dude.
     
  6. jmr40

    jmr40 Member

    Joined:
    May 26, 2007
    Messages:
    9,899
    After being sued numerous times, both Marlin and Winchester added crossbolt safeties which made it safer to load and unload their lever actions. Having a ND while loading or unloading them has been fairly common over the years.

    This is different from the Remington problem however. In every case someone either pulled the trigger while unloading, or let the hammer fall while trying to lower it on a live round. I don't think anyone has ever claimed one of the lever actions fired without one of the above happening.

    I don't care for the safeties they have added, but they do add an extra layer of protection in case someone messes up while loading or unloading.
     
  7. jsimmons

    jsimmons Member

    Joined:
    Feb 12, 2008
    Messages:
    213
    The only way the gun could have gone off was if there was a round chambered and the trigger pulled. If he was loading a weapon that had one in the chamber, it was his fault - not the gun's.
     
  8. CraigC
    • Contributing Member

    CraigC Member

    Joined:
    Jan 27, 2006
    Messages:
    14,281
    Location:
    West Tennessee
    Sounds like pure negligence to me. I abhor safeties and rebounding hammers on leverguns. IMHO, they only serve to protect the idiots from themselves.
     
  9. kaferhaus

    kaferhaus Member

    Joined:
    Nov 26, 2004
    Messages:
    739
    Location:
    Mobile, Alabama
    Better get this guy out of your club immediately. Next time he could kill someone or himself... which would likely get the club sued.
     
  10. jerkface11

    jerkface11 Member

    Joined:
    Oct 27, 2005
    Messages:
    5,498
    Location:
    Arkansas
    Why were they loading a gun on the front porch?
     
  11. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    NO. If it had, the case would have ruptured and the bullet would still be inside the action.

    The guy had to pull the trigger after operating the lever and closing it, which cocked & loaded it.

    No lever-action will fire out of battery.
    He either forgot it was cocked & loaded, and pulled the trigger.
    Or pulled the trigger to lower the hammer and let it slip out from under his thumb.

    In either case, he was negligent, not to mention chambering a round on the back porch in the first place.

    rc
     
    Last edited: Nov 22, 2010
  12. cleardiddion

    cleardiddion Member

    Joined:
    Dec 4, 2007
    Messages:
    1,353
    Location:
    US
    It wasn't a mechanical failure, I'd put money on it.
    WHat I think happened was that he loaded it, chambered a round, and was playing with the hammer and let it slip from full cock.
     
  13. DPris

    DPris Member

    Joined:
    Nov 4, 2007
    Messages:
    4,455
    RC,
    Actually, they can theoretically fire out of battery, at least partially.
    That's the reason for the trigger block on many models.
    Denis
     
  14. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Yes, I know that.

    But I assumed since it was a 30-30 lever-action, it was a Winchester 94, or a Marlin 336.

    Neither one can fire out of battery.
    And again, you would have a ruptured case as evidence if it did.

    rc
     
  15. DPris

    DPris Member

    Joined:
    Nov 4, 2007
    Messages:
    4,455
    When you said "No lever-action will fire out of battery" I was adjusting the comment slightly for those who may not understand the difference between the Model 94 & earlier guns like the 92s and so on. :)
    Agree on the rest.
    Denis
     
  16. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Actually, the 92 can't fire out of battery either.

    The mechanics are different then the 94, but the result is the same.

    rc
     
  17. DPris

    DPris Member

    Joined:
    Nov 4, 2007
    Messages:
    4,455
    :D
    Denis
     
  18. GIJOEL

    GIJOEL Member

    Joined:
    Feb 5, 2010
    Messages:
    284
    Location:
    Milwaukee, WI
    I don't think the rifle was hammer fired, after looking at some pictures I think it was a marking. The guy is one of the owners of the cabin and should have known better than to load up on the porch. I suspected that he must have hit the trigger, just wanted to know if there were any known problems with lever action rifles that could have caused the round to go off.
     
  19. DPris

    DPris Member

    Joined:
    Nov 4, 2007
    Messages:
    4,455
    The earlier leverguns could fire out of battery, if certain conditions occurred.
    Parts wear & parts breakage could cause it.

    The '66 Winchester levergun repro I have here has no trigger block & no firing pin "block" to prevent it happening.
    The hammer can fall on the firing pin when still out of battery, and the firing pin will protrude through the bolt's breechface. If a cartridge happens to be contacting the breechface at such a moment, it can fire, even if the bolt's not fully closed.

    There were apparently enough instances where this happened for the '73 Winchester to include a trigger block.
    When Browning designed the '92, he left out the trigger block, but did include a mechanical "firing pin block" that immobilised the pin inside the breechbolt till the action was fully closed & in battery.
    (The term "firing pin block" is used loosely, more of a result than a specific part.)

    There were apparently still enough out of battery incidents to cause him to put the trigger block back in the '94.

    I wouldn't go so far as to say "No" levergun can fire out of battery. :)
    Denis
     
  20. Leadhead

    Leadhead Member

    Joined:
    Mar 16, 2007
    Messages:
    963
    Location:
    Canada
    That's why the gun should be pointed in a safe direction when loading/unloading.

    A hammer spur can help with hammer control when lowering the hammer to the half cock and for extra safety or if your hands are cold you can block the hammer with the web of your front hand or your sling or some other handy item like a piece of leather that you have brought along for that purpose...
    I've got good hands and have never slipped... but I still point it in a safe direction!
     
  21. Red Cent

    Red Cent Member

    Joined:
    May 20, 2010
    Messages:
    2,384
    Location:
    McLeansville, NC by way of WV SASS 29170L
    The early 66s did not have a lever safety to prevent firing out of.battery. The later ones do as does the 73s and on.
    Dpris, I was under the impression all '66 repros had the lever safety. Been shooting cowboy for over nine years and I ain;t saw one yet.
    I have 73s with lever safety removed. Screws up the rythmn on a short stroke. Never fired one out of battery yet. Where is some wood to knock on?
     
  22. DPris

    DPris Member

    Joined:
    Nov 4, 2007
    Messages:
    4,455
    Red,
    The Uberti '66 carbine in .44-40 that I bought at the first SASS convention has no trigger block.
    Don't think I've ever seen one that does. :)
    Denis
     
  23. bigfatdave

    bigfatdave Member

    Joined:
    Jul 13, 2008
    Messages:
    5,961
    Location:
    Near Camp Perry
    Well, you got lied to, probably.
    And if that was his exact phrasing, claiming "I didn't even touch the trigger" would have been a lot more believable.
     
Thread Status:
Not open for further replies.

Share This Page