Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

LNL AP mods 1

Discussion in 'Handloading and Reloading' started by sugarmaker, Oct 14, 2011.

Thread Status:
Not open for further replies.
  1. sugarmaker

    sugarmaker Member

    Joined:
    Jan 24, 2010
    Messages:
    546
    Location:
    VT
    Some pictures of some mods on my press

    1st is a modified pusher for the case feed - it is very reliable, does not jam. Machined from 2024 bar stock.

    2nd is a dillon powder check actuated by the LNL powder drop mechanism - made from a cut off l bracket.

    3rd is the on press trimmer - simultaneous with a redding body die size. Trims, inside and outside chamfer.

    4th is the result of the trim. It's sub .001" accurate, nearly perfect chamfwer and deburr, takes 1 sec per .006" of trim or about 2 seconds of pause on top of the stroke to be safe. turns at 600rpm. Chips vacuumed by shop vac w/ attachment, not shown.

    5 second cycle time from empty case to loaded round including trim, no inside case neck lube (using lee collett on station 1)

    A few more interesting things if anyone is interested.
     

    Attached Files:

  2. dbarnhart

    dbarnhart Member

    Joined:
    Mar 6, 2011
    Messages:
    527
    Location:
    Phoenix, AZ
    I am envious of your machining skills.
     
Thread Status:
Not open for further replies.

Share This Page