Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Load for P6 reliability

Discussion in 'Handloading and Reloading' started by mudriver, May 2, 2009.

Thread Status:
Not open for further replies.
  1. mudriver

    mudriver Member

    Joined:
    Oct 14, 2007
    Messages:
    128
    Any recommendations on some good loads that ensure my P6 works 100%? I'm using it for IDPA, etc.
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Just pick a load out of your reloading manual for the bullet you choose to use.

    If it's anything like my P6, it isn't picky.
    Mine has handled everything I have tried in it, including the floor sweepings from under the loading bench.

    rc
     
  3. Hikingman

    Hikingman Member

    Joined:
    Sep 10, 2005
    Messages:
    277
    124 gr. FMJ or 'plated' and 4.3 of W231.
     
  4. mudriver

    mudriver Member

    Joined:
    Oct 14, 2007
    Messages:
    128
    Thanks for the suggestions.

    Right now it doesn't like Bullseye and 115g fmj
     
  5. atblis

    atblis Member

    Joined:
    Feb 19, 2005
    Messages:
    4,530
    Location:
    Neither here nor there
    Generally

    Generally for reliability if you have enough oomph, the powder doesn't matter.

    Usually it's the bullet, the case, OAL, or some other exterior dimension.
     
Thread Status:
Not open for further replies.

Share This Page