Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

M1 Garand glass bedders out there?

Discussion in 'Rifle Country' started by mshootnit, Apr 7, 2010.

Thread Status:
Not open for further replies.
  1. mshootnit

    mshootnit Member

    Joined:
    Feb 4, 2007
    Messages:
    2,016
    Have any of you guys glass bedded an M1 before?
    I have the stock and supplies on hand and I have glass bedded several bolt rifles, but this one is so different. I have a NRA pub. with some detailed and (for me) hard to read tech. drawings, my stock has the grooves inletted already but nothing on the interior of the stock as far as bedding around the bottom of the receiver. When I fit the action to the stock a little of one of the rear grooves is showing. There is also a little slop but not when I lock it up to the trigger group. Does that sound about right? Where do I put bedding around the inside of the stock along the bottom of the receiver? Any advice appreciated.
     
  2. Hangingrock

    Hangingrock Member

    Joined:
    Mar 10, 2010
    Messages:
    1,850
    Location:
    NC
  3. Slamfire

    Slamfire Member

    Joined:
    Dec 29, 2006
    Messages:
    7,523
    Location:
    Alabama
    The grooves are un necessary with modern two part epoxies. When the original instructions were written, epoxies had the consistency of honey. Ran all over the place.

    If you get an epoxy like Devcon SS filled, Marine Tex, both of which are like thicker than peanut butter, you can mill the inside sidewall just leaving some outer side wall for support.

    Epoxy the full length and depth of the receiver tangs and sidewalls. Mill out enough wood so you can slap in a thick sidewall of epoxy.
     
Thread Status:
Not open for further replies.

Share This Page