1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

M14/m1a nm flash suppressor

Discussion in 'Rifle Country' started by Captkaos, Jan 31, 2011.

Thread Status:
Not open for further replies.
  1. Captkaos

    Captkaos Member

    Jan 30, 2011
    Newnan, Ga
    I recently installed a springfield national match with bayonet lug...dig the old school look. When properly installed it has proper bullet clearence, however, it is slightly canted. Is my attention to detail being wasted on a common problem that even the original m14 usgi had. My question is...is there a simple way to fix this or just leave it as a slight imperfection. Thanks for any input out there.
Thread Status:
Not open for further replies.

Share This Page