Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

M16-A1 light primer strikes

Discussion in 'Rifle Country' started by Baneblade, Mar 30, 2009.

Thread Status:
Not open for further replies.
  1. Baneblade

    Baneblade Member

    Joined:
    May 20, 2007
    Messages:
    391
    Location:
    Northern Arizona
    I am looking for a little help with one of our department rifles. One of our M-16A1 rifles is encountering light primer strikes on full auto. It seems to be every 5 rounds or so. There is a small mark on the primer, but definately not enough to fire the round. Ammo is not the problem, the magazines are good, the gun is clean. It only occurs on full auto.

    I have not had a chance to test fire it yet (we don't have an actual range) and would like some ideas of what to look for beyond the Armorer (Colt M-16/AR-15 certification) level. I have inspected the weapon and there are no obvious problems. I will tear into it today, but other than an early hammer release/timing issue I'm not sure what this would be... assuming the gun is properly cleaned.

    Feel free to give me any ideas.

    The rifle is a refurbished military M-16 A1 rifle purchased by my department. Serial number is around 1.5 million.
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    That sounds like a normal firing pin ding from when the round chambered.
    Every chambered round will have a small ding from the floating firing pin if you don't shoot it.

    Could it be it just is not catching the hammer occasionally and the hammer is following the bolt down?

    Hammer or sear or spring problem probably.

    rc
     
  3. Baneblade

    Baneblade Member

    Joined:
    May 20, 2007
    Messages:
    391
    Location:
    Northern Arizona
    It is getting more than just the firing pin tap. It appears the hammer is releasing early, but the disconnect is holding it so that it does not just follow the bolt.
     
  4. redneckdan

    redneckdan Member

    Joined:
    Jul 2, 2006
    Messages:
    482
    check the timing first.
     
  5. Jeremy2171

    Jeremy2171 Member

    Joined:
    Feb 23, 2007
    Messages:
    848
    Location:
    In a Retired Marines Valhalla
    Pull the hammer spring and ensure one of the "legs" isn't broken.
     
  6. Baneblade

    Baneblade Member

    Joined:
    May 20, 2007
    Messages:
    391
    Location:
    Northern Arizona
    It was the sear spring. I had thought it was a timing issue. The spring was intact except for one small part of the leg. The piece that holds spring to the sear was broken so the sear could just flop back and forth.

    Thanks for the help. At least it was an easy fix.
     
Thread Status:
Not open for further replies.

Share This Page