Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

M1A Trigger Group Wear

Discussion in 'Rifle Country' started by Winston_Smith, Feb 21, 2010.

Thread Status:
Not open for further replies.
  1. Winston_Smith

    Winston_Smith Member

    Joined:
    Jul 14, 2008
    Messages:
    356
    Location:
    TX
    Is this type of wear normal on M1As?

    DSCN6835.jpg
     
  2. wayne in boca

    wayne in boca Member

    Joined:
    Sep 7, 2005
    Messages:
    377
    Location:
    south Florida
    Yes,kinda normal.It's from trying to install the trigger group (500 times)without looking at it very closely and screwing it up.I take a little file to them every now and then and clean up the edges.
     
  3. Dave P

    Dave P Member

    Joined:
    Dec 24, 2002
    Messages:
    1,600
    Location:
    North Florida
    yes, and no real effect on anything.
     
  4. Winston_Smith

    Winston_Smith Member

    Joined:
    Jul 14, 2008
    Messages:
    356
    Location:
    TX
    Thanks guys. It just didn't look right to me and was making me a little nervous.
     
  5. madcratebuilder

    madcratebuilder Member

    Joined:
    Jul 15, 2007
    Messages:
    5,020
    Location:
    Northern Orygun
    +1

    If you file a slight bevel at the start of the slot it well help with alignment.
     
Thread Status:
Not open for further replies.

Share This Page