Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Marlin Bullseye

Discussion in 'Rifle Country' started by 76shuvlinoff, Dec 26, 2008.

Thread Status:
Not open for further replies.
  1. 76shuvlinoff

    76shuvlinoff Member

    Joined:
    Jul 6, 2007
    Messages:
    2,289
    Location:
    Michigan
    The Bullseye has been missing from my 39A for years. I bought one from Brownells for $2.95. Looks simple enough but has anyone actually replaced one of these? The thing is all least twice as long as the hole in the stock is deep. I am not sure if this is normal or if there is something wedged in there. I am really leerly of grabbing up my Dewalt and just drilling it out. Looking at my 1894c the bullseye is contoured to match the curve on the stock, this could be interesting to accomplish and avoid marring the finish on the 39A stock. I'm no cabinet maker LOL!

    If I get that far would a dab of Gorilla glue be a good choice to hold it?

    Thanks,
    Mark
     
    Last edited: Dec 26, 2008
  2. SGW42

    SGW42 Member

    Joined:
    Dec 20, 2007
    Messages:
    742
    Location:
    Houston!
    I would sand/file down the bullseye itself before I drilled the stock any deeper.

    Then once you have the correct length, "contour" the bullseye out of the stock, fit checking it every so often until it looks nice.

    I just recently resoled a pair of shoes with Gorilla Tape, so I imagine the glue is good enough for the job.
     
  3. jmr40

    jmr40 Member

    Joined:
    May 26, 2007
    Messages:
    10,083
    Location:
    Georgia
    I glued mine in and left the excess protuding from the stock. After the glue dried I used masking tape to tape over the stock around the bullseye then carefully filed down. The tape will protect the stock if you let the file slip. The stock is rounded so you want to be able to match the contour of the bullseye to the stock.

    Cutting it off a bit will reduce the amount of filing needed but you need some extra to work with to make it look right.
     
Thread Status:
Not open for further replies.

Share This Page