Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

mauser action reface

Discussion in 'Gunsmithing and Repairs' started by mustang_gt_350, Nov 28, 2006.

Thread Status:
Not open for further replies.
  1. mustang_gt_350

    mustang_gt_350 Member

    Joined:
    Nov 8, 2006
    Messages:
    98
    Does anyone know if a receiver facing cutter like the ones sold at brownells for the rem. 700 (the non lathe using style) is available for the large ring mauser?
    and if so what are you thoughts on them? and well even if not available what are you thoughts of using these compared to turning it on a lathe?
    thanks
     
Thread Status:
Not open for further replies.

Share This Page