1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mauser help

Discussion in 'Gunsmithing and Repairs' started by Byron Quick, Apr 4, 2003.

Thread Status:
Not open for further replies.
  1. Byron Quick

    Byron Quick Moderator In Memoriam

    Dec 21, 2002
    Waynesboro, Georgia
    I've got a Mauser 98k from SOG. It shoots fine. The only problem is that cycling the bolt is somewhat stiff when you keep the rifle on your shoulder. How can I smooth this out?
  2. dfariswheel

    dfariswheel Member

    Dec 26, 2002
    First, I'd try giving the bolt assembly a good cleaning with a solvent, drying and lubing with a good grease. Make sure to grease the cocking ramp on the bolt.
    Often this will be all that's needed, since the bolts are usually crudded up with old dirt and grease.

    Since it's an older Mauser, it's probably broken in, so if that doesn't work put a bit of fine valve grinding compound on the area where the cocking piece engages the ramp cut on the bolt.

    Tie the trigger back with wire or tape so the action won't cock, then just raise and lower the bolt handle to lap the surfaces smooth.
    When the area is smooth, clean everything THROUGHLY with solvent to remove all the abrasive, then lube the parts with a good grease.

    DON'T overdo this, you can break through the hardening, and it doesn't take much anyway.
Thread Status:
Not open for further replies.

Share This Page