Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mini 14-- Advice, Where to Buy

Discussion in 'Rifle Country' started by Glock Novice, Jun 3, 2011.

Thread Status:
Not open for further replies.
  1. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    Hello All,

    I am a long time lurker, first-time poster and I've finally thought up a query worth posting. After much consideration, I've chosen a *used* mini-14 to be my first long-gun purchase. After saving up some more, I plan to send it off to GunDoc to have it fixed up with the works-- bedded, barrel shortened and crowned, etc.

    Now the question: Because the rifle is going to be accurized anyway, I'm not interested in one of the fancy new series. Does anyone know a reliable vendor, or venue, from which I could purchase a used Mini ranch rifle for $450-$550?


    I pray that this doesn't become a thread for mini-bashing, I have my reasons for this decision and no amount of whining about expensive mags or sub-AR accuracy will make me change my mind (the factory mags at Hoffman's are actually quite reasonable).

    Any help (or mini tips) is and are greatly appreciated,

    Many thanks,

    Glock Novice
     
  2. briansmithwins

    briansmithwins Member

    Joined:
    Aug 1, 2005
    Messages:
    4,132
    Just wondering, why send it out for accurizing before you know how it shoots?

    BSW
     
  3. Z-Michigan

    Z-Michigan Member

    Joined:
    May 19, 2008
    Messages:
    4,047
    Location:
    Michigan
    The new series doesn't just have accuracy improvements, it also has a better fit of pretty much all parts. The old tooling was worn out, but still in use past where it should have been retired. If you get a 586+ new series you will be better off even with gunsmith work on top of it. And they can be had for under $600 via CDNN, and probably elsewhere too.

    If you still want used, I would watch Gunbroker and check local pawn shops. Look for one that shows little wear (of course), and absolutely never was used by law enforcement or game officers (because of the likely high round counts).
     
  4. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    Can never be too accurate ;)

    In all seriousness, though, the older series of Minis has some minor flaws (thin barrel, too long, too much barrel whip, general inaccuracy) that, once corrected, make for a far better rifle. The gunsmith I mentioned is widely considered an expert with Minis. Thus the necessity for getting one on the cheap.

    I could pay $700 for a new one that shoots maybe 2" groups, or

    pay for used, $500, plus $300 in tuning and have a rifle that shoots 1" groups.
     
  5. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    Z-Michigan,

    Thank you for the advice, I'll check out CDNN. I'm not fixated on the fix-up plan, I just want to get the most out of the platform.

    And that's why I love THR
     
  6. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    I'm moving from Maine to California for school, and I want something I can take back and forth. If I built or bought an AR, FAL, AK, or anything with a pistol grip or "the thing that goes up", i.e. a bayonet lug, I'd have to install a bullet-button. That's like asking someone to only swill light beer or chase Christian girls.

    With the Mini, I have nice wood furniture that won't scare the sheeple, a reliable platform, and the ability to carry ten rounders in CA and thirty-round happy boxes when I'm home on break.

    Compromise, gentlemen, is a terrible thing, but it makes the world go round.

    I wish I had enough cash for an M1A, but I have to pay student tuition, at least until I can get the military to pay for it.
     
  7. wow6599

    wow6599 Member

    Joined:
    Apr 6, 2008
    Messages:
    2,417
    Location:
    Wildwood, MO
    Don't listen to the Mini bashers, they don't know any better.
    I have a 581 series NRA Mini that will do 1" groups @ 100 yards all day long. Not a better feeling then going to the range and out-shooting all the AR fanboys.
     
  8. merlinfire

    merlinfire Member

    Joined:
    Feb 2, 2010
    Messages:
    793
    New series 580+serialed Mini-14 is a good gun.

    Old series sometimes yes, sometimes not.
     
  9. Vern Humphrey

    Vern Humphrey Member

    Joined:
    Dec 30, 2002
    Messages:
    18,719
    Location:
    Deep in the Ozarks
    From www.gunsamerica.com




     
  10. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    I'll definitely be keeping an eye on GunsAmerica, too. Thanks for the help gentlemen. If anyone has any more information about minis, California, or alternative, yet similar long arms that suit my purposes, I would be more than thankful.
     
  11. M1key

    M1key Member

    Joined:
    Oct 18, 2007
    Messages:
    2,550
    Location:
    SW
    I moved from Kali in 1990...so I am aware of the "compromise".

    Minis are fine for what you want.

    Good luck.

    M
     
  12. JAV8000

    JAV8000 Member

    Joined:
    Jun 11, 2009
    Messages:
    199
    Location:
    Ft. Riley, Kansas
    Here's a review of my 581 tactical mini......It's been a fantastic weapon system, no complaints! I think you'll find that with a few inexpensive improvements you won't need to spend a bunch to make a 581 mini shoot good.

    http://www.thehighroad.org/showthread.php?t=574331
     
  13. USAF_Vet

    USAF_Vet Member

    Joined:
    Jan 6, 2011
    Messages:
    5,773
    Location:
    Hastings, Michigan
  14. Z-Michigan

    Z-Michigan Member

    Joined:
    May 19, 2008
    Messages:
    4,047
    Location:
    Michigan
    Your California issue makes sense, but bear in mind that bullet buttons can be removed in a few minutes when you're out of state, and reinstalled in the same few minutes when you go back to Kommiefornia.

    As for other rifles, perhaps a Saiga in stock form? I think those are CA-legal. Possibly some other neutered AKM derivatives too. Otherwise the Mini makes sense with a sub-$1200 budget.
     
  15. Skyshot

    Skyshot Member

    Joined:
    Jan 23, 2011
    Messages:
    936
    Location:
    Tn.
    If you look around you could probably find a new 581 tatical for around $600. And yes they shoot very good, Before you send the gun off why don't you by a barrel stabilizer like an accustrut and install it. It might save you some bucks. It will improve the accuracy. My 581 shoots about 1 to 1 1/2 moa at 100 yards and thats about what my two ARs shoot. Good luck,
     
  16. 45EER

    45EER Member

    Joined:
    Oct 12, 2009
    Messages:
    15
    Location:
    NC Mountains Gods Country.
    Ruger Minis

    Odd how M1 & M1A fans seem to take IMHO just 1 more of Garands
    designs. Yep the Ol togle bolt Mini 14/30 that Ruger made. Back
    when Mini 30s wers under $200.00 new I built 2 Bisonite beded
    Mini 30s for my Wife & I. Nantahala National Park means land of
    the noon Day Sun. So I took 2 Butler creek Folding stocks the Wife
    did a professionel camo job. Having not only built M1s & M14s/M1As
    trained in the Military getting these 2 Minis to follow the rules was not
    easy. I free floated rather than try to create a lock up point, I did get a crisp
    4lb single stage trigger. ( Warning) the Ruger trigger is not like any
    M1 or M1A trigger in fact I had to have few holes drilled & tapped for
    allen set screws. Don't try honing or changing angles, get someone
    who is setup to do mini trigers. Anyway with the thick foliage &
    Rotodendren Hells the shots are close, so the Leoupold compact scopes
    IMI brass with AA 1680 Powder & the no longer made .308 135gr
    Spizer flat base single shot pistol bullet we stayed unger 1 MOA
    at our range. It was a tech at Sierria who told me about how well
    the 135 SSPB did on deer west of the Mississippi in the 7.62 X39.

    I would have never made High Master with a Mini 30, but I would
    not like to have tried to carry a full weight NM M1A down the center of
    my back. That Mini folded & carried nice & light in the center of my back
    While my walking stick poked & proded for Timber Rattlers & Copper
    heads under rocks & logs. there thick in the south side when warm.

    So get that mini 14 & build it into your dream rifle, we did & are now
    using them for Feral hogs & Coyotes. I have been shooting since
    the late 60s & I have never seen as many recalls on Firearms & Ammo.
    Ruger is a 1 Company I still hear good things about them.

    Mike
     
  17. mstreddy

    mstreddy Member

    Joined:
    Jul 15, 2010
    Messages:
    1,333
    Location:
    SE Fla -- land of sunshine, liquid and otherwise.
    Glock Novice - PM Sent regarding 2 Minis that I am selling.
     
  18. Glock Novice

    Glock Novice Member

    Joined:
    Aug 22, 2010
    Messages:
    25
    Hello everyone,

    Many thanks for your advice. I've received some offers of sale, and PMs are inbound. Taking into consideration what I've read on this thread, I've decided on the newer series of rifle, serial number #580 and up. I figure that I can accustrut and build up from there.

    Glock Novice


    EDIT-----

    Now, if anyone has a used Mini-14 of the series I mentioned, for less than $600 cold, hard American, I'd love to talk to you.
     
    Last edited: Jun 3, 2011
  19. SGW42

    SGW42 Member

    Joined:
    Dec 20, 2007
    Messages:
    742
    Location:
    Houston!
    Bud's just recently had a bunch older law enforcement GB model trade-ins for cheap. If they're out then I am sure they are still floating on Gun Broker, etc.
     
  20. dprice3844444

    dprice3844444 member

    Joined:
    Feb 26, 2011
    Messages:
    4,264
    Location:
    se fla i love claymores 01/sot
  21. mtrmn

    mtrmn Member

    Joined:
    Apr 22, 2011
    Messages:
    877
    Location:
    Louisiana
    www.jgsales.com seems to advertise used minis a lot.
    Mine (183 series) broke the bolt and I sent it to Ruger. They sold me a new one (entire firearm) for a special price which I won't divulge. I haven't tried it yet.
     
  22. 4v50 Gary

    4v50 Gary Moderator Staff Member

    Joined:
    Dec 19, 2002
    Messages:
    18,989
    Glock Novice - I feel your pain about California.
     
Thread Status:
Not open for further replies.

Share This Page