Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mini-14 Harris Bipod Install Question

Discussion in 'Shooting Gear and Storage' started by gopackgo, Nov 12, 2012.

Thread Status:
Not open for further replies.
  1. gopackgo

    gopackgo Member

    Joined:
    Oct 23, 2011
    Messages:
    24
    Location:
    Wisconsin
    I just installed a Harris HBRS 6-9 in. bipod on my Mini-14 using the HB14 adapter. I installed as recommended in the Harris instructions, but I end up with a gap between the adapter and the forearm stock. Try as I might, I couldn't get the adapter flush. Am I doing something wrong? The installation seems rock solid, even after multiple test deployments; I haven't taken it to the range yet, so I don't know how it will handle recoil. I have seen some pictures of this bipod installed, most flush, some with a gap. Any advice or comments?
     

    Attached Files:

    • 018.jpg
      018.jpg
      File size:
      135.2 KB
      Views:
      16
    • 020.jpg
      020.jpg
      File size:
      137.4 KB
      Views:
      18
  2. Jaxondog

    Jaxondog Member

    Joined:
    Feb 3, 2012
    Messages:
    480
    Location:
    Culbreth NC
    Nice looking rifle, but it's a little hard to tell much with those shot's. Maybe a little closer and clearer.
     
  3. OpticsPlanet

    OpticsPlanet Member

    Joined:
    Oct 14, 2011
    Messages:
    823
    Location:
    Northbrook, IL
    I sold my Mini last year, but there was a gap with my Harris bipod adapter as well. Still was rock solid, and did not affect the use in any way.

    Mark H.
     
Thread Status:
Not open for further replies.

Share This Page