Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Moly coated bullets in Glock barrels?

Discussion in 'Handguns: Autoloaders' started by BlayGlock, Dec 25, 2009.

Thread Status:
Not open for further replies.
  1. BlayGlock

    BlayGlock Member

    Joined:
    Jan 18, 2009
    Messages:
    865
    Location:
    Texas
    I have been told that you are not supposed to shoot regular lead bullets through factory Glock barrels due to the way that they are rifled. Are moly-coated bullets okay to shoot in Glocks?

    I am going to start reloading 9mm for IDPA and I am loooking for a good source of bullets, moly seams to be cheaper than the alternative?
     
  2. distra

    distra Member

    Joined:
    Dec 3, 2005
    Messages:
    1,799
    Location:
    IA
    I and several of my fellow shooters, use Precision Bullets in our Glocks. They work just fine. These a coated with a tough polymer that keeps the lead off your barrel and from vaporizing during shooting. I shoot both 9mm and .45ACP through my Glocks. I do clean them after 500 or so rounds, but that's me.
     
  3. R. Deckard

    R. Deckard Member

    Joined:
    Mar 12, 2006
    Messages:
    81
    Location:
    Dallas, TX
    moly bullets

    I also use 147 precision moly coated bullets in my Glock 34. Round count is problebly close to over 6000 rounds, not a single problem. I'll run a bore snake thought it each time before a match and clean it real good about every 500 rounds.

    Deckard
     
  4. BlayGlock

    BlayGlock Member

    Joined:
    Jan 18, 2009
    Messages:
    865
    Location:
    Texas
    Thanks for the info guys. I dont think it would be a problem. I clean my guns after every range session.

    R. Deckard, Why do you use 147 gr as opposed to 115?
     
    Last edited: Dec 25, 2009
Thread Status:
Not open for further replies.

Share This Page