Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

My first rifle and the problem I remember

Discussion in 'Rifle Country' started by neviander, Mar 21, 2008.

Thread Status:
Not open for further replies.
  1. neviander

    neviander Member

    Joined:
    Feb 3, 2008
    Messages:
    547
    Location:
    Kilgore, TX
    First of all, I haven't shot this gun in over 10 years, it's only seen the light of day from it's case probably 5 times in those 10 years, so no gripes about how dirty it is :neener:

    ANYhoo, as I am catching up on my wonderful U.S.A.'s wonderful gun culture on this fantastic forum, I got to thinking about this nagging problem I had with my very first rifle. It is a Magtech model 122, bolt action .22 lr.

    I remember clearly after maybe 1000 rounds or so the piece of metal that is supposed to eject the spent casing quit spitting out the casings for me. I have to flick out the spent casing manually every time. Does anyone have any suggestions as to how to fix this problem? I'm sure those that are familiar with this style rifle will know which part I am talking about. Pic is below.

    [​IMG]
     
  2. DnPRK

    DnPRK Member

    Joined:
    Mar 30, 2003
    Messages:
    646
    Location:
    LA, CA
    To properly eject, the case has to be firmly held against the bolt face. That allows the ejector to knock the case out through the receiver port. I suspect the extractors are letting go of the case too soon.

    Remove the bolt. Then remove the left and right extractors and clean them and any gunk in the bolt recesses that prevent free movement of the extractors. Reassemble the extractors into the bolt (the extractor with the sharp hook goes on the right).
     
  3. psalmsinger

    psalmsinger Member

    Joined:
    Mar 10, 2008
    Messages:
    18
    Location:
    The People's Republic of Massachusetts
    I don't see the pic, but I'll guess that the problem could be that you lost the ejector. On that model, it is simply held in with a screw, which probably went away together. The rifle was made by CBC in Brazil, and parts are hard to find 'round here (imported c. 1992, I think). But, maybe with this info, you can find, or get ye to your local gunsmith for better advice as to whether it is worth the hassle to fix.
     
  4. jrfoxx

    jrfoxx Member

    Joined:
    Sep 23, 2004
    Messages:
    2,168
    Location:
    Evanston,WY
  5. neviander

    neviander Member

    Joined:
    Feb 3, 2008
    Messages:
    547
    Location:
    Kilgore, TX
    Holy wow, yeah, there was a ton of gunk on the extractors; all over the bolt really. I guess I was afraid of taking anything apart when I was 16. Thank you for the prompt replies guys, I'll let ya know if it works now, I suspect it will.
     
  6. icebones

    icebones Member

    Joined:
    Feb 2, 2008
    Messages:
    585
    Location:
    You ain't from around here, KY
    is it the extractor or ejector?

    sometimes fouling can get into the extractor groove and cause it to bind and break, especially is it is made of metal that is either too soft (wears quickly) or is too hard (snaps off, cracks or breaks)
     
Thread Status:
Not open for further replies.

Share This Page