Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

My WASR stock is on TIGHT

Discussion in 'Rifle Country' started by TheDisturbed1, Dec 31, 2006.

Thread Status:
Not open for further replies.
  1. TheDisturbed1

    TheDisturbed1 Member

    Joined:
    Dec 28, 2006
    Messages:
    620
    Location:
    Interior Alaska
    I have done nealry everything i could think of to get this poor thing off... They must have slapped that stock on when it was dripping wet with factory finish. I removed all screws i could find (2), and tried to wedge it out with a screwdriver wherever i could jam it in without damaging the stock or screwdriver.

    How the Hell does this thing come off?
     
  2. bthest86

    bthest86 Member

    Joined:
    May 7, 2006
    Messages:
    362
    Location:
    Mexico
    You've probably already tried this but for what its worth remove the cover and stick the screwdriver in the top of the reciever between the metal and the stock and lever it out with all your strength. You may need to use your foot or a mallet.

    You may need to scuff the stock a bit but I never worried about scuffing up the part of the stock that sticks inside the reciever anyway.

    As long as the two screws are out it should pop out easily. Thats the only way I know of to get it out.
     
  3. TheDisturbed1

    TheDisturbed1 Member

    Joined:
    Dec 28, 2006
    Messages:
    620
    Location:
    Interior Alaska
    Thanks

    Thanks a bunch. I had to drive the screwdriver in that tiny gap i had, but it came loose. :D
     
Thread Status:
Not open for further replies.

Share This Page