Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need a S&W K-Frame Hammer

Discussion in 'Gunsmithing and Repairs' started by boo586, Jun 10, 2003.

Thread Status:
Not open for further replies.
  1. boo586

    boo586 Member

    Joined:
    Jan 3, 2003
    Messages:
    84
    Location:
    Indianapolis
    Hello everyone!!

    I am looking for a hammer assembly for my recently purchased Model 15 S&W K-Frame (Square butt). Does anyone have a K-frame hammer with a hammer mounted firing pin lying around that they do not want (I am willing to buy it and pay shipping)? I am thinking about replacing the original hammer with the used one which I want to remove the hammer spur on and remove the single action sear and make the gun a DAO for carry purposes. Has anyone ever done this before? HOw much would a new hammer assembly cost?

    Thanks,

    Boo586
     
  2. dfariswheel

    dfariswheel Member

    Joined:
    Dec 26, 2002
    Messages:
    6,140
    Gun Parts Corporation sells factory new S&W hammers INCLUDING new hammers that are factory converted DA-only without the hammer spur.
    It might be cheaper in the long run to simple buy one from them.

    As an example, they offer a DA-only hammer for the M-66:
    Smith & Wesson 66
    Item No. 315810D
    Hammer, Bobbed, Stainless
    Retail Price: $43.60

    It will need miniumal fitting, and the DA conversion is already done. It will fit your M-18.

    Look through the listings for a non-plated "stainless" DA hammer.

    http//:www.e-gunparts.com
     
  3. dsb1829

    dsb1829 Member

    Joined:
    Sep 23, 2010
    Messages:
    185
    Location:
    Huntsville, AL
    Is 9 years too old to be relevant?

    Searching for a m-66.

    Looks like Numrich still list the bobbed hammer, but are out of stock. Any other ideas? Doesn't have to be SST.
     
  4. chrisf8657

    chrisf8657 Member

    Joined:
    Nov 25, 2006
    Messages:
    203
    Location:
    Phoenix, AZ
    The S&W factory typically has a ton of parts for old guns too laying around (although the one you need always seems to be the one they dont have LOL). Might want to give them a call too.
     
  5. rromeo

    rromeo Member

    Joined:
    Mar 17, 2010
    Messages:
    523
    Location:
    SW, VA USA
    I have a bobbed hammer from a M10.
     
  6. dsb1829

    dsb1829 Member

    Joined:
    Sep 23, 2010
    Messages:
    185
    Location:
    Huntsville, AL
    That'd do I will take this offline and send you a pm.
     
Thread Status:
Not open for further replies.

Share This Page