Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need a source for G10 grips...don't laugh!

Discussion in 'Handguns: General Discussion' started by jonboynumba1, Feb 9, 2010.

Thread Status:
Not open for further replies.
  1. jonboynumba1

    jonboynumba1 Member

    Joined:
    Oct 16, 2007
    Messages:
    451
    Location:
    Ala-freaggin'-Bama!
    OK I need them for a NAA mini revolver (.22 mag) in black G10 I found a place on Ebay that sells a pocketknife clip equipped pair but the lines are a little weird...I was just more or less wanting standard shaped grip pannels but in G10 laminate with maybe some texturing...mostly to match another gun and knife it will be comboed with at times...because it'll just look neat IMHO It's not a serious "carry gun" I just have one and want it to match some other carry stuff....so anyone have a source for a place that offers them or might make a set reasonably priced? With the bazillion of these things out there I'm surprised nobody has grabbed this niche...NAA offers a pretty good selection but not G10...help a Bubba out if you have a link or company suggestion.

    PS- I posted this here cause there are probably more auto guys buying G10 than revolver guys...and we all like knives and a lot of the G10 companies seem to make a lot of knife handles as well as gun grip panels...I didn't want to put it in autoloaders since it's not (gun in question) and didn't think revolvers would get much traffic (tend to be more functional rubber or pretty wood guys IMHO) Anyway if there is such a beast out there...I aims to buy me a set of em!
     
  2. Aka Zero

    Aka Zero Member

    Joined:
    Jul 23, 2008
    Messages:
    551
    Location:
    Missouri
    You could always buy some g10? It's easy to work with, just wear a respirator when cutting and sanding.
     
  3. John Wayne

    John Wayne Member

    Joined:
    Dec 11, 2007
    Messages:
    1,133
    There are a lot of places that make custom knife handles, inlays, etc.

    G-10 is a commonly used material in making knife handles, and the NAA grips are smaller than most knives. I would try a custom knifemaker.
     
  4. highorder

    highorder Member

    Joined:
    Oct 7, 2007
    Messages:
    4,350
    Location:
    Cincinnati
Thread Status:
Not open for further replies.

Share This Page