Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need barrel vise action wrench and 308 finish reamer

Discussion in 'Gunsmithing and Repairs' started by Mountainman1888, Jan 31, 2012.

Thread Status:
Not open for further replies.
  1. Mountainman1888

    Mountainman1888 Member

    Joined:
    Jan 27, 2012
    Messages:
    14
    Hey Gents,
    I have a Remington 700 chambered in 22-250 and need some tools change the barrel. I have a Shaw .308 varmint contour barrel. It is threaded and short chambered. I was hoping to rent the tools to keep the cost of this build down.
     
  2. NCsmitty

    NCsmitty Member

    Joined:
    Jun 29, 2008
    Messages:
    5,325
    Location:
    North Carolina
    I have used 4D rentals in years past for the reamers, and they always provided new or equal to new cutters that did the job very well. They also have gunsmith tools and accessories, so check with them for the action wrench and barrel vise.
    I don't know if you have reamed a chamber before, but a short chambered barrel doesn't require much reaming, and a sharp reamer can go too far in a heartbeat, so just a word of caution. Flush the chamber of chips with air or fluid and check your headspace gauge frequently.
    I believe if you use a credit card, you won't need a deposit.

    http://www.4-dproducts.com/index.php


    NCsmitty
     
  3. Mountainman1888

    Mountainman1888 Member

    Joined:
    Jan 27, 2012
    Messages:
    14
    Thanks I will investigate that option. Yes It is my first barrel swap so I'm going to take my sweet time
     
Thread Status:
Not open for further replies.

Share This Page