Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need Dimensions for the Lyman #457677 Bullet

Discussion in 'Handloading and Reloading' started by Seth Hawkins, Aug 6, 2010.

Thread Status:
Not open for further replies.
  1. Seth Hawkins

    Seth Hawkins Member

    Joined:
    Sep 15, 2006
    Messages:
    15
    Location:
    Jacksonville, NC
    Got it. Thanks.
     
    Last edited: Aug 7, 2010
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Whats wrong with using an off the shelf Lyman or RCBS lube/sizer die?

    You just need a #677 top punch and a sizing die that fits your rifles bore measurement after you slug & measure it.

    Bullet:
    http://www.lymanproducts.com/lyman/bullet-casting/mould-details-rifles.php?entryID=78

    Lubrisizer dies:
    http://www.lymanproducts.com/lyman/bullet-casting/hi-sizing-dies.php

    Top punches:
    http://www.lymanproducts.com/lyman/bullet-casting/top-punches.php

    These will fit either Lyman or RCBS lubrisizers.

    rc
     
  3. Seth Hawkins

    Seth Hawkins Member

    Joined:
    Sep 15, 2006
    Messages:
    15
    Location:
    Jacksonville, NC
    Got it. Thanks.
     
    Last edited: Aug 7, 2010
Thread Status:
Not open for further replies.

Share This Page