Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need Glock Fire control Help!

Discussion in 'Gunsmithing and Repairs' started by beaverboard, Jan 20, 2005.

Thread Status:
Not open for further replies.
  1. beaverboard

    beaverboard Member

    Joined:
    Jan 6, 2004
    Messages:
    9
    I installed a Scherrer 3.5lbs disconnector in my Glock 17 a couple of days ago. I ran two mags through it with no problems. Tonight when I went out to shoot the gun would either not reset the trigger or it would fire two to three round bursts. While that was certainly fun and exciting, it is not desirable. Anyone have any guess why it has decided to switch to burst fire? Thanks in advance for any help.
    DC
     
  2. Quintin Likely

    Quintin Likely Member

    Joined:
    Dec 29, 2002
    Messages:
    898
    Location:
    Relay 3, Target 17
    Tried those guys over at Glocktalk.com? I'm not familiar with the different trigger connectors and springs you can run in Glocks, so I've no idea what you did, but if anyone did, they would.
     
  3. JeffC

    JeffC Member

    Joined:
    Dec 1, 2003
    Messages:
    270
    Location:
    Northern Va.
    I haven't messed with Glocks in quite a while, but I'd ditch the 3.5 connector and go back to the factory connector. There was a problem with some Alchemy Arms 3.5 connectors but Scherer were always considered higher quality.... However, Scherer connectors still aren't as good as Glock's connector.

    Definitely a question you should ask over at Glocktalk....
     
  4. beaverboard

    beaverboard Member

    Joined:
    Jan 6, 2004
    Messages:
    9
    I got the opportunity to see my gunsmith this morning, he seemed to think that I had a mis-shaped disconnector. So I plan to contact Scherer monday. Thanks for the help.
    DC
     
Thread Status:
Not open for further replies.

Share This Page