Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need help!Bsa E-Z hunter reticle

Discussion in 'Rifle Country' started by Muzzlelover, Nov 14, 2012.

Thread Status:
Not open for further replies.
  1. Muzzlelover

    Muzzlelover Member

    Joined:
    Oct 29, 2012
    Messages:
    59
    I have looked all over the internet trying to find a chart or list of cartridges compatable with this reticle and have found nothing.I'm sorry about wasting a post but I was wondering if anyone found a chart or owns a scope with this reticle.thanks.
     
  2. gamestalker

    gamestalker member

    Joined:
    Sep 10, 2008
    Messages:
    9,832
    Location:
    SW Arizona
    I use a Leupold RX-IV with the TBR program and it's spot on. After I determine the fps I sellect the program that corresponds. I then know the hold over needed, and the MOA at the turret to dial it in.

    GS
     
  3. Jackal

    Jackal Member

    Joined:
    Mar 9, 2006
    Messages:
    4,373
    Location:
    Northwest Washington
    Any cartridge is compatible. You just zero as usual, then hold over with each mark and measure the rise in inches on your target. Then use this : http://www.handloads.com/calc/ to calculate the distance it will correspond with. Example: If the bottom aiming point is hitting 10 inches high at 100 yards with a 50gr .223 at 3200fps, then it will be dead on at 270 yards.

    Nikons BDC reticle is the same way. I even use the bottom edge of a duplex reticle as an aiming point in this manner.
     
Thread Status:
Not open for further replies.

Share This Page